Power Generation and Distribution

Our Ration for the course : 4.7 Start Based on 56 users

Gas-turbine starting arrangements

Distribution of turbine energy; to compressor, generator, auxiliaries, and stack. Vs. Gas turbine efficiency

Combustion igniters, and flame detectors / Water and steam injection

Combustor arrangements / Combustion air, and secondary air / Factors affecting air temperature rise through the combustion section

Effect of pressure ratio on efficiency / Potential for compressor stall at start-up / Variable inlet guide vanes

Exhaust heat recovery / Axial flow and centrifugal flow compressors

Typical values of temperature and pressure "through cycle" / Single shaft and two shaft arrangements

The gas-turbine cycle / Conversion of heat to mechanical energy

Single Line Diagram & Distribution Layout

Types of Distribution Substation

Name of Course	Scheduled Dates	Vanue	Registration Link
Power Generation and Distribution	To be determined	Abu Dhabi, UAE	Registration Now

Introduction

Electric power distribution is the final stage in the delivery of electric power; it carries electricity from the transmission system to individual consumers. Distribution substations connect to the transmission system and lower the transmission voltage to medium voltage ranging between 2 kV and 35 kV with the use of transformers. Primary distribution lines carry this medium voltage power to distribution transformers located near the customer's premises. Distribution transformers again lower the voltage to the utilization voltage used by lighting, industrial equipment or household appliances. Often several customers are supplied from one transformer through secondary distribution lines. Commercial and residential customers are connected to the secondary distribution lines through service drops. Customers demanding a much larger amount of power may be connected directly to the primary distribution level or the subtransmission level.

Course Objectives

Duration & Learning Level

Learning Level:

Intermediate

Duration:

3 days

Power Generation and Distribution

Upon completion of this course participants will be able to know:  GE Gas turbine cycle in details.  Generator Construction, Operation & Troubleshooting.  Power Transformers Construction, Operation & Troubleshooting. Power Distribution System.  The gas-turbine cycle  Conversion of heat to mechanical energy  Typical values of temperature and pressure "through cycle"  Single shaft and two shaft arrangements  Exhaust heat recovery  Axial flow and centrifugal flow compressors  Effect of pressure ratio on efficiency  Potential for compressor stall at start-up  Variable inlet guide vanes  Combustor arrangements  Combustion air, and secondary air  Factors affecting air temperature rise through the combustion section  Combustion igniters, and flame detectors  Water and steam injection  Distribution of turbine energy; to compressor, generator, auxiliaries, and stack. Vs. Gas turbine efficiency  Gas-turbine starting arrangements  Accessory gear box drive to auxiliaries  Control of gas turbine output  Generator Construction - Excitation Systems, voltage & frequency Control  Generator auxiliary systems - Normal & Abnormal operations  Generator maintenance activities  Stator and rotor visual inspection - Generator electrical tests  Single Line Diagram & Distribution Layout  Power & Auxiliary Transformers  Distribution Substation Construction  Distributed power and local networks  Types of Distribution Substation

Exam & Certificate

Completion Certificate will be awarded after training

Target Group

Operation Engineers, Power Plant Operators & foremen

1. How do I enroll/register for the training course?

To enroll or register to any training course, you can use the registration page from training page or fill the request a call back form from each course pages. The following page will provide you a list of course and training that we are providing based on the category and from each course item you can see the course details.
URL: https://nbizinfosol.twtests.co.in/training.aspx
Another method is to fill a Request a call back form provided in each Training/Course pages.